Covid-19 Update!! Current supply status.
Outbound Deliveries: Allow a few extra days for both Australian and overseas deliveries.
Pre-orders and Backorders: Allow a few extra days due to quarantine precautions.
316 - Precision - Technical
Precision - 316 Stainless Steel Bearings
This table covers tolerances for bearings made from 316 Stainless Steel
Note! 316 Stainless Steel is not a standard bearing steel and is less precise and softer than standard bearing stainless steel.
Dimensions are in 0.001 mm (thousandths of a mm)
1 mm = 0.03937 of an inch. 1 micron (um) = 0.00003937 of an inch
To obtain the tolerance in inches multiply the figure shown by 0.00003937
eg. 76.2 um x 0.0000397 = 0.002999994 inches (about 3 thou.)
|Bearing Size||Tolerance in um|
|Bore <= 19.050 mm||0.000 / +76.200|
|Bore > 19.050 mm||0.000 / +101.600|
|OD <= 25.400 mm||-76.200 / 0.000|
|OD > 25.400 and <= 41.275||-101.600 / 0.000|
|OD > 41.275 and <= 50.800||-127.000 / 0.000|
|OD > 50.800||-152.400 / 0.000|
|Width||0.000 / +127.000|
Log in and start browsing the Miniature Bearings Australia Online Catalogue pages.All care has been taken in the compilation of this page, however errors may occur. Please do not use the information contained herein for critical applications without first re-checking the information with an independent source. No responsibility will be accepted by Miniature Bearings Australia Pty Ltd or the Directors of said company for any loss of any kind that may be incurred in any way whatsoever from use of the information provided in these pages.
----- Trademarks -----
Delrin is a registered trademark of duPont Corporation
Teflon is a registered trademark of duPont Corporation
Viton is a registered trademark of duPont Corporation
Torlon is a registered trademark of BP Amoco
Tables and information on this web site should be read as a general guide only.
All relevant standards should be consulted to ensure the accuracy of information presented.
For a huge range of bearings online please visit the Bearing Shop Online Website.
The Small Parts and Bearings has a much larger range of engineering supplies.
Hobby and Engineering Supplies lists a smaller range of products and only the most popular items in each range. They also list many additional hobby specific categories.
Extra information for Technical - Precision
Registered Australian Company: Miniature Bearings Australia Pty Ltd (ABN 94 069 113 800)
Information on this website is Copyright Miniature Bearings Australia 1997. All rights reserved.